Manual of Military Training - James A. Moss (read dune .TXT) 📗

Keep your knife clean by washing in soap and water after every meal.

Do not use the blade as a pry.

If the point is broken, grind the blade down to a new point.

1305. Fork. Keep your fork clean by washing with hot water and soap after every meal.

Never use the prongs of your fork for prying open tops of cans, extracting corks, etc.

Don't permit your knife, fork or spoon to remain in vinegar or other foodstuffs for a long period, as verdigris will form. This corrodes the metal and is poisonous.

1306. Spoon. Keep your spoon clean by washing with soap and water after every meal.

1307. Meat can. Do not carry meat of any kind or other greasy substance in the meat can for a long period, as it will corrode the aluminum.

If the rivets securing the hinge to the meat can become loose, a few blows with a hammer or hand ax on the outside ends of the rivets, the heads of the rivets being backed up on a piece of metal, will tighten them.

If the hinge pin becomes loose, a nail can be used to replace it, the nail being cut with a service wire cutter and the ends of the nail headed over slightly with a few blows of a hammer.

1308 Bacon can. The interior of the bacon can should always be kept clean and free from hardened grease or dirt by frequent washings with soar and water.

If the cover becomes loose on the body of the can, the upper half of the body may be bent out until the cover is again tight.

If the cover is too tight, a slight amount of flattening with a hammer on the edge of the cover, resting on a wooden block, will usually extend the cover sufficiently.

1309. Condiment can. When not in use, always remove the contents. Many cans have been ruined by neglecting to do this.

See that the threaded ends do not become rusty.

The can should be disassembled at all inspections, so that the inspecting officer may see that no rust is present.

1310. Cup. The cup is made of aluminum and excessive heat damages aluminum.

In using the cup for cooking never allow the contents to evaporate entirely. In other words, never hold an empty cup over a fire.

Keep your cup clean with hot water and soap,—preferably H & H soap.

1311. Canteen. Although as a rule, only soap and water should be used in cleaning aluminum, a little sand can be used to advantage in cleaning the canteen.

Particular attention must be taken to see that canteens are properly cleaned after they have been filled with coffee, milk or any other fluid containing organic matter.

Being made of aluminum the canteen is easily dented, and care must be taken to prevent this.

When not actually in use the canteen should habitually be emptied and the cup left off to dry.

1312. Pick mattock. If the blade of the mattock is deformed, it should be straightened in a vise.

In the field, cracked handles of pick mattocks, shovels, and hand axes should be wrapped with cord.

1313. Shovel. Do not use the side edges of the shovel blade as a mattock, for this will deform the blade.

If the blade becomes bent, straighten it with a hammer on a block of wood.

Keep your intrenching tool free from rust, being especially careful that no rust gets into the sockets.

1314. General. Because of the value of leather equipment and its rapid deterioration if neglected, the proper care of leather is most important.

1315. Materials. Two agents are necessary to the proper cleaning of leather,—a cleaning agent and an oiling agent.

The cleaning agent issued by the Ordnance Department is castile soap; the oiling agents are neat's-foot oil and harness soap.[16]

The soap cleans the surface of the leather, and removes from the surface pores of the leather, dirt, sweat, and other foreign matter, so that the oil can more readily penetrate the pores and saturate the fibers, thus making the leather pliable and elastic.

1316. Cleaning. Daily, or as often as used, leather equipment should be wiped off with a cloth slightly dampened in water, merely to remove mud, dust or other foreign substances.

This daily care will do much to maintain the appearance of the equipment, but it is, however, insufficient of itself to properly preserve it.

Leather should never be cleaned by immersing in water or holding under a hydrant.

At intervals of from one to four weeks, depending upon the circumstances, it is essential that the equipment be thoroughly cleaned in accordance with the following instructions:

(a) Separate all parts, unbuckle straps, remove all buckles, loops, etc., where possible.

(b) Wipe off all surface dust and mud with a damp (not wet) sponge. After rinsing out the sponge, a lather is made by moistening the sponge in clear water, squeezing it out until nearly dry, and rubbing it vigorously upon castile soap. When a thick, creamy lather is obtained, thoroughly clean each piece of the equipment without neglecting any portion. Each strap should be drawn its entire length through the lathered sponge so as to actually remove the salt, sweat, and dirt from each leather piece.

(c) After again rinsing the sponge make a thick lather as described above with the saddle soap. Go over each separate piece, thoroughly working the lather well into every part of the equipment, remembering that its action is that of a dressing.

(d) After the leather has been allowed to become partially dry, it should be rubbed vigorously with a soft cloth to give it the neat, healthy appearance that is desired.

1317. Oiling. If the foregoing instructions have been carefully followed, the appearance should now be perfect, and if the leather is soft and pliable nothing further is required. It will be found, however, that it will be necessary from time to time to apply a little oil. It is not practicable, owing to different conditions of climate and service, to prescribe definitely the frequency of oiling. It has been found that during the first few months of use a set of new equipment should be given at least two applications of oil per month. Thereafter it is entirely a matter of judgment, as indicated by the appearance and pliability of the leather. Frequent, light applications are of more value than infrequent heavy applications.

1318. New equipment. Before using, perfectly new equipment should in all cases be given a light application of neat's-foot oil; soap is unnecessary because the leather is clean. The application of oil is important because leather equipment frequently remains a considerable time in an arsenal or depot and in spite of periodical inspections and dubbing it is probably too dry for severe service.

1319. How to apply oil. The quantity of oil to be used can not be definitely prescribed. If not enough oil is used, the leather will be stiff and brittle; if too much is used, it will soil the clothing and accumulate dirt. The leather should, therefore, be saturated with sufficient oil to be soft and pliable without excess sufficient to cause it to exude.

In applying the oil the following general instructions should govern:

(a) The oil should be applied to the flesh side of the equipment where practicable when the leather is clean and still damp after washing (about half dry), because it penetrates more uniformly when applied from the flesh side, and when the leather is damp. If the leather is dry it will absorb the oil like blotting paper, preventing proper distribution.

(b) The oil should be applied with an oiled rag or cotton waste by long, light, quick strokes—light strokes, so that the pressure applied may not squeeze out an excess of oil; quick strokes, so that the leather may not absorb an undue amount of oil. The endeavor should be to obtain a light, even distribution.

(c) After applying the oil the leather equipment should be allowed to stand for 24 hours, if practicable, in a warm dry place. It should then be rubbed with a dry cloth to remove any unabsorbed oil.

1320. Therefore, from what has been said, the following points must be remembered:

(a) Keep leather clean.

(b) Keep leather pliable by frequent applications of oil.

(c) Use only materials furnished by the Ordnance Department. Shoe polishes, etc., are almost invariably injurious.

(d) Dry all leather wet from whatever cause, in the shade; never in the sun or close to a steam radiator, furnace, or boiler.

(e) Leather should habitually be stored in a cool, dry place, without artificial heat.