bookssland.com » Fiction » Textiles and Clothing - Kate Heintz Watson (open ebook TXT) 📗

Book online «Textiles and Clothing - Kate Heintz Watson (open ebook TXT) 📗». Author Kate Heintz Watson



1 ... 6 7 8 9 10 11 12 13 14 ... 24
Go to page:
stitch is an alternate slanting back stitch, the needle being placed first to the right and then to the left. This stitch must be worked evenly to be effective. It is used to finish flannel seams and hems, fasten down linings, opened seams, and canvas facings and featherbone, in millinery—in fact, this stitch is one of the most useful in sewing. The catch stitch is a variation of the cat stitch. Instead of pointing the needle towards the chest, the stitch is taken parallel with the chest. It is used for about the same purposes as the cat stitch. As with the outline stitch, the cat stitch is worked from the worker.
Loop Stitch

(4) Blanket or loop stitch, used to ornament the edge of blankets, etc., and for finishing the edge of stockinet or web material, is worked from left to right, the edge of the material being held towards the worker. Start with three or four running stitches along the edge so the line of stitching will cover them. Insert the needle the desired width from the edge, draw it towards you down over the thread, being careful not to draw the thread too tightly over the edge of the flannel. Fasten the thread by taking running stitches under the last blanket stitch on the wrong side.

HEM STITCHING HEM STITCHING
a—Position of Needle; a'—Finished Hem Stitch; b—Ladder Stitch; c—Example of Drawn Work Finished with Loop and Cat Stitches.
Feather Stitch

(5) Single, double, and triple feather or coral stitches may be made very ornamental and are used in all kinds of sewing and on all materials. They are always made towards the worker, the stitches being taken alternately to the right and left of the line of the design. The thread should always be carried under the needle as in a buttonhole stitch. The design may be varied by taking the stitches diagonally or straight, by making them close or separated, etc.

Hem Stitch

(6) Hemstitching is used for ornament in making hems and tucks. The first step in hemstitching is the drawing of threads. Rubbing the cloth along the line of threads to be drawn will make the drawing easier if the cloth is sized. After the threads are drawn, the hem is turned and basted even with the lowest edge of the drawn space. Insert the needle into the edge of the hem and material, taking up a cluster of threads bring the thread under the needle to form a buttonhole stitch or make a simple stitch in the edge of the fold. The number of threads drawn and the number in a cluster must be determined by the coarseness or fineness of the material, the greater number being drawn and taken in fine material. There are several methods of hemstitching, but the results are about the same.

EMBROIDERY STITCHES EMBROIDERY STITCHES
Eyelet Embroidery, Embroidery Button Hole, Flat Satin Stitch.
French Knots

(7) French knots are used in connection with other stitches for borders enclosed in outline and chain stitches, in initials, centers of flowers, and as a filling-in stitch. The simplest method is of taking a small back stitch, bringing the thread from the eye of the needle under the point from right to left and drawing the needle perpendicularly from the cloth. Place the needle back of the knot and bring the point out in the place where the next knot is to be made. The size of the thread will determine the size of the knot.

Embroidery Buttonhole

(8) The embroidery buttonhole stitch has many possibilities and many variations. It is worked from left to right instead of from right to left as in a buttonhole. The thread from the work is carried under the point of the needle from left to right, just the reverse of the buttonhole. This stitch is used on flannel and in embroidery of all kinds; it may be padded or worked flat and the stitches may be taken a distance apart or near together.

Cross Stitch

(9) The cross stitch is worked on linen, scrim, canvas, or any open-meshed material. If done on a flat, smooth surface, it will be necessary to work over canvas, afterwards drawing out the canvas threads. The canvas should be well basted on the material, the warp threads of the canvas lying perfectly straight on a line with the warp threads of the material on which the pattern is worked. The stitches should always run the same way. If the first ground stitches are made from left to right, from bottom towards the top, the cross stitches should be made from right to left from the top towards the bottom. All the ground stitches run one way and the cross stitches in the opposite way.

This stitch is used for marking table linen, underwear, and embroidery designs. When marking linen and unlined work, make the under side very neat by running the thread under the stitches already made, instead of taking a long stitch when beginning in another part of the letter or design.

Satin Stitch

(10) The satin stitch is an over and over stitch and is used on materials of all kinds for marking linen, etc.

The padding is the first step and should be done in long even stitches placed closely and over one another in the center. The size and proportions of the figure or letters determine the size of the thread. Fine thread gives the best results. The outline should be run twice; this keeps the edge firm. An even darning or basting stitches, chain stitches or outline stitch may be used if the space is not too small. The padding may be worked in an embroidery hoop to keep it smooth and even. Scallops may be padded in the same way or worked flat.

EMBROIDERY BUTTON HOLE AND BLANKET STITCHES EMBROIDERY BUTTON HOLE AND BLANKET STITCHES
Scallops Outlined and Padded.

In large figures the stitches are laid closely and exactly parallel the entire length of the form. They may be straight across or at an angle, but the one slant must be maintained throughout. In small curved figures, the stitches may be placed more closely at the inner edge and spread slightly at the outer edge. In flat work where the leaf or petal is large, two or three stitches taken in the cloth, back of the face stitch, holds them even and prevents misplacement in laundering. (All embroidery should be ironed on the wrong side.)

ARROW HEAD, DOUBLE ARROW HEAD AND CROW'S FOOT. ARROW HEAD, DOUBLE ARROW HEAD AND CROW'S FOOT.
Eyelet Embroidery

Eyelet embroidery is a simple over and over stitch forming a smooth, round edge. Like satin stitch, all outlines are run with an even darning stitch, except the very small eyelet holes, made with a stiletto. Long or oval openings must be cut through the center.

Shadow Embroidery

Shadow embroidery is worked on the wrong side of thin material, using the cat stitch. The outline of the design only shows on the right side, the body of the design being seen dimly through the material.

Arrow Heads

The arrow head and crow's foot are ornamental fastenings used in fine tailoring as endings for seams, tucks, plaits, and at corners. They are made as shown in the illustration.

Mercerized cotton, linen, or any of the embroidery silks can be used for these stitches, in all sizes and colors, or they can be worked with ordinary thread, cotton or linen, sewing silk, or twist. Cotton thread wears better than linen.

HEMS
Folding Hems

A hem is a fold of goods twice folded to protect a raw edge. The first turn or fold of the hem is the most important. It should be straight and even, folded to a thread, for upon it depends the beauty of the hem. The hem should always be turned towards the worker and creased firmly, but never pleated along the fold. First crease the narrow fold, then crease the second fold the desired width, marking by a measure and baste not too near the edge. The first fold along the woof threads should be at least one-fourth of an inch in width, as the woof threads give or stretch more than the warp threads; otherwise it will not lie flat.

Sewing Hems

In sewing the hem, the needle should take up only the edge to be hemmed down and just enough to hold on the cloth or lining. In white work the stitches should be fine, showing as little as possible.

Bias Hem

All bias and curved edges should have the first fold basted. In cloth or silk this first basting thread should match the material and not be taken out.

Faced hem

A facing or faced hem is also used as a protection to the edge of a garment. A true bias or fitted facing should be used for a facing if the edges of the garment are curved. An extension hem is one in which the whole width of the hem is used.

HEMMING HEMMING
a—Shows method of cutting to do away with a clumsey corner.

Slip-Stitching

Slip-stitching or invisible hemming is done on silk, wool, and thick material. The hem is pressed with an iron, a stitch as fine as possible is taken on the surface of the cloth and the needle slipped under and through the first fold, drawing the thread lightly. The needle and thread used in this stitch must be very fine.

MITERED CORNERS MITERED CORNERS
Method of Folding and Cutting.

Rolled Hem

Rolled hem and whipped gathers are made with the wrong side of the material next the worker. Make a tiny roll of the edge towards the worker, using the left thumb and index finger, rolling an inch at a time (and no more) before hemming. Make fine, even stitches in the roll and goods. Keep the hem perfectly round, firm and not too large. This hem is adapted only to fine material and the edge across the warp is the more easily rolled.

ROLLED HEM AND WHIPPED GATHERS ROLLED HEM AND WHIPPED GATHERS
a—Rolled Hem Gathered; b—Whipped Roll; c—Double Whipped; d—Roll Hemmed; e—Gathers Sewed to Band.
Whipped Gathers

To gather, whip the rolled hem without hemming, making overcasting stitches towards you, even and not too fine. Use coarser thread than for hemming. This gathering thread is used to hold down the edge as well as for drawing up the gathers and it not to be taken out, as is the ordinary gathering thread. It should not catch in the roll. Have the thread the length of the plain space to which it is to be sewed and regulate the gathers as you do the gathering. After the edge is rolled, whipped and gathered, it is sewed to the garment by the little scallops or raised parts made by the whipping. This is used only for making ruffles or gathering on very fine hand work.

French Hem

The French hem is used for table linen. Fold as in an ordinary hem, then fold the hem back on the right side and overhand the edge formed, taking fine stitches. Press the hem flat from the right side.

Flannel Hems

Flannel hems should not be twice folded, for there will be a ridge instead of a flat surface after the garment has been laundered, owing to the felting properties of the wool. Hems on flannel should not be stitched by hand or machine, but cat stitched on the wrong side and finished on the right side with any ornamental stitch.

Hems in infants' clothing may be turned on the right side and made ornamental by feather stitching.

No selvage should ever be used on a hem. The selvage is more closely woven and will draw or pucker in laundrying.

TUCKS

Tucks are folds made on thin

1 ... 6 7 8 9 10 11 12 13 14 ... 24
Go to page:

Free e-book «Textiles and Clothing - Kate Heintz Watson (open ebook TXT) 📗» - read online now

Comments (0)

There are no comments yet. You can be the first!
Add a comment